I have noticed that after a few weeks of working in my local development environment that, randomly, I can only do 1 or two changes in the backoffice before it basicaly stops responding. After these couple of changes clicking on anything will just sit there and act as if it is loading/processing. This can be from just trying to load a content node or even just a doc type. If I close the debug and rerun it then it works for a couple of changes then it happens all over again. If I delete the local DB and then restore from my umbraco cloud project it will be fine for a while. I am not 100% but I think it only starts to happen AFTER I pull down any changes that happen up in the umbaco cloud environment and merge them into local (like if umb cloud does an upgrade on me) Anyone seen this or have any ideas on what might be going on?